Build Summary


GENERAL INFO

Ford Transit 2017 350 HR Cargo Van
148" Wheelbase
3.5L GTDI V6 Engine (Ecoboost)
6-Spd Auto Select Shift TR
Exterior Oxford White - Interior Pewter Vinyl
  Hi Roof - Long Wheel Base (148) - Extended Body
3.31 Ratio Fegular Axle X31
9500# GVWR Package
Reverse park aid -Trailer Tow Package - AM/FM Stero W/Sync - Cruise Control - Load Area Protection PKG with Vinyl
Floor

BUILD ORDER

1)  REMOVE EXISTING PANELS AND FLOOR
  • Save all plastic panels
  • Keep floor in until needed for replacement

2)  METAL WORK
  • Weld all steel necessary for cabinets, beds and tracking.
  • Weld Flat Metal reinforcing for Cabinet/Panel Bed Install
  • Window Cutouts for two windows
  • Roof Cutouts (1 fantastic vent fans)
  • Chassis water fresh water tank - size up to 20 gallons
  • Chassis grey water holding tank mounting - around 10 gallons

3) INSULATION

4) ELECTRICAL PRE-WIRE
    • Run wiring for lights, roof vents, water pumps, solar panel, etc. before you cover ceiling. Run all wires to designated area for switches and/or control panel
      5) INSTALL  CEILING AND THEN FLOOR AND THEN WALLS

        6) INSTALL WALL CABINETS


        7) INSTALL FLOOR CABINETS (4 total - built of 1/2" marine plywood to finish with varnish)
        • Back platform bed with storage underneath
          with a set of 3 drawers to be installed in front of platform with knobs that lock them closed
        • 22"deep x 18" wide (+/-) floor to ceiling cabinet for fridge
        • 49" wide bench with storage underneath seat (lift up seat to show storage)
          and an oval opening in the seat back to allow for more storage
        • 40" (+/-) wide sink base to begin at platform and end before step into side of van
        8) INSTALLATION of EQUIPMENT
        • RML8330 8-SERIES REFRIGERATOR
          depth 23 1/2 " x height 50 14/16 " x 16 1/2"
        • Solar Panels on roof (if there is time) Electrical Parts to Install

        No comments:

        Post a Comment